- 0
Asked by
Sathesh Sivashanmugam,
-
Similar Topics
-
By 5zwed
Hi,
I've recently bought a 65QNED913PA TV (currently with latest official software) and I connected my Bluetooth headset to it - Jabra Elite 85t. Whenever I try to use pause button on my headset (while watching YouTube, Netflix, Disney,...) sound gets muted, but video does not pause. When I push the button again sound comes back and nothing else happens. Should my TV support pausing video from my headset or this does not work by default?
Regards
Maciej
SUPPORT MENU -
By David Daul
My magic remote and my Roku remote stopped working for turning off power so I performed a factory reset after troubleshooting to get the remote working. I am now stuck at the 1st screen of the Factory Reset which says "Press the OK Button(wheel) on your remote." Well... this really stinks because the remote doesn't work!!! I have tried a USB mouse, a new magic remote, other LG Remotes with no luck. I have also tried using the button on the bottom of the tv. And, I contacted support which was just an exercise in redoing everything I had already tried... No Luck!!
This is a Nano Cell 55NANO81ANA which is basically just a big brick now since I cannot even use any of the inputs. Does anyone have a trick for getting past this initial screen???
Thanks for the help.
-
By dvoina
Hi!
I have a 49SK7900PLA TV and the remote has seen better days...
I am wondering if I can pair it with the new AN-MR22GN remote that costs half the price of an AN-MR20GA (the one that I currently have).
TV is running software version 06.10.30
-
By SGray
Hi - My LG television is currently being bombarded by my toddler messing with the physical control panel, mainly for the volume. Separate to this, I always like to have an Android-enabled remote as I don't always have the physical remote at my side.
As I did with my old Samsung television prior to upgrading, I disabled the physical buttons on the television using Hotel Mode. I did it on my LG and it was perfectly fine... Until I went to use the LG ThinQ Android app. What followed was days of head scratching why suddenly my LG app was not working - In the end because a few days had passed, my toddler wasn't interested in the non-working physical buttons, I decided to play around with the Hotel Mode - This is when I found that there was a direct conflict between the Android app and Hotel Mode being enabled.
I tried on a different phone with the same results. However toddler has once again realised the physical buttons work - So in the process of pulling out my hair. I did have another remote app which worked well on my Samsung television, but LG seemed to have nixed it on support so I cannot use the third party app.
Is there a light at the end of the tunnel??
-
By Gecko64
Hello, the wifi of my smart TV is broken since the last update.
The remote control from my phone too when i use an opérational ethernet connection.
Tried :
Full setting reset
Reboot
Power reset
Observed :
After the power reset and unplugged during at least 10 min, the WiFi networks was at new listed but impossible to connect, it says WiFi network not found.
After a new power off, the searching of wifi networks didn't end without result.
The remote control also lag a lot each 10 seconds and during 3 or 4 seconds.
TV Informations :
Model : 49SJ800V-ZB
Devide Name : [LG] webOS TV SJ800V
Serial Number : 711MAVDM8903
webOS TV Version : 3.9.0-62709 (dreadlocks2-dudhwa)
MAC Wired : 38:8C:50:F3:2B:5D
MAC Wireless : 7C:1C:4E:A0:E8:C7
ESN : LGTV20171=11002626448
VSN : 5DBF066A
Widevine : LGTV17CLGE005126094
Question :
Is there a way to downgrade by putting the firmware on a USB Key with a FAT 32 filesystem on to be sure it could be read by the TV ?
Thank you in advance for your help.
-
-
-
Similar Tagged Content
-
- 0 answers
- 2,639 views
-
- 4 replies
- 6,153 views
-
- 2 replies
- 3,267 views
-
- 0 replies
- 3,710 views
-
Question
Sathesh Sivashanmugam
Hi,
I am using MacBook with El Capitan OSX. When I start the emulator (3.0, 2.0 and 1.2) it crashes immediately. When I start the emulator manually from Oracle Virtual box it starts fine. But not with the remote.
Link to comment
Share on other sites
Top Posters For This Question
1
Popular Days
Aug 17
1
Top Posters For This Question
Sathesh Sivashanmugam 1 post
Popular Days
Aug 17 2016
1 post
0 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.